Plastic linear sliding bearing manufacturers analyze how to design the bearings?

How about the quality and price of bearing supply, bearing wholesale? When we choose high-quality products, we must understand the general situation of the bearing manufacturer! Bearing manufacturers share the design attention of bearings for you. What should bearing manufacturers pay attention to when designing bearings? The bearing should be designed so that the oil film can smoothly enter the friction surface. The oil ring must be fully and reliably supplied with oil. Prevent sharp edges and corners that cut off the oil film. Sliding bearings are in surface contact, so a certain oil film must be maintained between the contact surfaces! If it is an oil tile, set an oil groove at its joint. The sharp edges and corners of the oil film should not be cut off. The oil must enter the bearing from the non-loading surface area. Also prevent sharp edges and corners that cut off the oil film. To facilitate disassembly, make the shaft shoulder height smaller than the outer diameter of the inner ring. If a higher shaft shoulder is required to apply heavy loads, install a groove on the shaft.